In the Linux kernel, the following vulnerability has been resolved:
nfsd: don't ignore the return code of svc_proc_register()
Currently, nfsd_proc_stat_init() ignores the return value of
svc_proc_register(). If the procfile creation fails, then the kernel
will WARN when it tries to remove the entry later.
Fix nfsd_proc_stat_init() to return the same type of pointer as
svc_proc_register(), and fix up nfsd_net_init() to check that and fail
the nfsd_net construction if it occurs.
svc_proc_register() can fail if the dentry can't be allocated, or if an
identical dentry already exists. The second case is pretty unlikely in
the nfsd_net construction codepath, so if this happens, return -ENOMEM.
In the Linux kernel, the following vulnerability has been resolved:
media: streamzap: fix race between device disconnection and urb callback
Syzkaller has reported a general protection fault at function
ir_raw_event_store_with_filter(). This crash is caused by a NULL pointer
dereference of dev->raw pointer, even though it is checked for NULL in
the same function, which means there is a race condition. It occurs due
to the incorrect order of actions in the streamzap_disconnect() function:
rc_unregister_device() is called before usb_kill_urb(). The dev->raw
pointer is freed and set to NULL in rc_unregister_device(), and only
after that usb_kill_urb() waits for in-progress requests to finish.
If rc_unregister_device() is called while streamzap_callback() handler is
not finished, this can lead to accessing freed resources. Thus
rc_unregister_device() should be called after usb_kill_urb().
Found by Linux Verification Center (linuxtesting.org) with Syzkaller.
In the Linux kernel, the following vulnerability has been resolved:
PCI/ASPM: Fix link state exit during switch upstream function removal
Before 456d8aa37d0f ("PCI/ASPM: Disable ASPM on MFD function removal to
avoid use-after-free"), we would free the ASPM link only after the last
function on the bus pertaining to the given link was removed.
That was too late. If function 0 is removed before sibling function,
link->downstream would point to free'd memory after.
After above change, we freed the ASPM parent link state upon any function
removal on the bus pertaining to a given link.
That is too early. If the link is to a PCIe switch with MFD on the upstream
port, then removing functions other than 0 first would free a link which
still remains parent_link to the remaining downstream ports.
The resulting GPFs are especially frequent during hot-unplug, because
pciehp removes devices on the link bus in reverse order.
On that switch, function 0 is the virtual P2P bridge to the internal bus.
Free exactly when function 0 is removed -- before the parent link is
obsolete, but after all subordinate links are gone.
[kwilczynski: commit log]
In the Linux kernel, the following vulnerability has been resolved:
jfs: add check read-only before truncation in jfs_truncate_nolock()
Added a check for "read-only" mode in the `jfs_truncate_nolock`
function to avoid errors related to writing to a read-only
filesystem.
Call stack:
block_write_begin() {
jfs_write_failed() {
jfs_truncate() {
jfs_truncate_nolock() {
txEnd() {
...
log = JFS_SBI(tblk->sb)->log;
// (log == NULL)
If the `isReadOnly(ip)` condition is triggered in
`jfs_truncate_nolock`, the function execution will stop, and no
further data modification will occur. Instead, the `xtTruncate`
function will be called with the "COMMIT_WMAP" flag, preventing
modifications in "read-only" mode.
In the Linux kernel, the following vulnerability has been resolved:
jfs: add check read-only before txBeginAnon() call
Added a read-only check before calling `txBeginAnon` in `extAlloc`
and `extRecord`. This prevents modification attempts on a read-only
mounted filesystem, avoiding potential errors or crashes.
Call trace:
txBeginAnon+0xac/0x154
extAlloc+0xe8/0xdec fs/jfs/jfs_extent.c:78
jfs_get_block+0x340/0xb98 fs/jfs/inode.c:248
__block_write_begin_int+0x580/0x166c fs/buffer.c:2128
__block_write_begin fs/buffer.c:2177 [inline]
block_write_begin+0x98/0x11c fs/buffer.c:2236
jfs_write_begin+0x44/0x88 fs/jfs/inode.c:299
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: add srng->lock for ath11k_hal_srng_* in monitor mode
ath11k_hal_srng_* should be used with srng->lock to protect srng data.
For ath11k_dp_rx_mon_dest_process() and ath11k_dp_full_mon_process_rx(),
they use ath11k_hal_srng_* for many times but never call srng->lock.
So when running (full) monitor mode, warning will occur:
RIP: 0010:ath11k_hal_srng_dst_peek+0x18/0x30 [ath11k]
Call Trace:
? ath11k_hal_srng_dst_peek+0x18/0x30 [ath11k]
ath11k_dp_rx_process_mon_status+0xc45/0x1190 [ath11k]
? idr_alloc_u32+0x97/0xd0
ath11k_dp_rx_process_mon_rings+0x32a/0x550 [ath11k]
ath11k_dp_service_srng+0x289/0x5a0 [ath11k]
ath11k_pcic_ext_grp_napi_poll+0x30/0xd0 [ath11k]
__napi_poll+0x30/0x1f0
net_rx_action+0x198/0x320
__do_softirq+0xdd/0x319
So add srng->lock for them to avoid such warnings.
Inorder to fetch the srng->lock, should change srng's definition from
'void' to 'struct hal_srng'. And initialize them elsewhere to prevent
one line of code from being too long. This is consistent with other ring
process functions, such as ath11k_dp_process_rx().
Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3.6510.30
Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.7.0.1-01744-QCAHKSWPL_SILICONZ-1
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: fix RCU stall while reaping monitor destination ring
While processing the monitor destination ring, MSDUs are reaped from the
link descriptor based on the corresponding buf_id.
However, sometimes the driver cannot obtain a valid buffer corresponding
to the buf_id received from the hardware. This causes an infinite loop
in the destination processing, resulting in a kernel crash.
kernel log:
ath11k_pci 0000:58:00.0: data msdu_pop: invalid buf_id 309
ath11k_pci 0000:58:00.0: data dp_rx_monitor_link_desc_return failed
ath11k_pci 0000:58:00.0: data msdu_pop: invalid buf_id 309
ath11k_pci 0000:58:00.0: data dp_rx_monitor_link_desc_return failed
Fix this by skipping the problematic buf_id and reaping the next entry,
replacing the break with the next MSDU processing.
Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3.6510.30
Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.7.0.1-01744-QCAHKSWPL_SILICONZ-1
In the Linux kernel, the following vulnerability has been resolved:
ntb_hw_switchtec: Fix shift-out-of-bounds in switchtec_ntb_mw_set_trans
There is a kernel API ntb_mw_clear_trans() would pass 0 to both addr and
size. This would make xlate_pos negative.
[ 23.734156] switchtec switchtec0: MW 0: part 0 addr 0x0000000000000000 size 0x0000000000000000
[ 23.734158] ================================================================================
[ 23.734172] UBSAN: shift-out-of-bounds in drivers/ntb/hw/mscc/ntb_hw_switchtec.c:293:7
[ 23.734418] shift exponent -1 is negative
Ensuring xlate_pos is a positive or zero before BIT.