In the Linux kernel, the following vulnerability has been resolved:
accel/ivpu: Add bounds check for firmware runtime memory
Validate that the firmware runtime memory specified in the image
header is properly aligned and sized to hold the firmware image.
This prevents errors during memory allocation and image transfer.
In the Linux kernel, the following vulnerability has been resolved:
mm/memory-failure: fix hugetlb_lock AA deadlock in get_huge_page_for_hwpoison
Two concurrent madvise(MADV_HWPOISON) calls on the same hugetlb page can
trigger a recursive spinlock self-deadlock (AA deadlock) on hugetlb_lock
when racing with a concurrent unmap:
thread#0 thread#1
-------- --------
madvise(folio, MADV_HWPOISON)
-> poisons the folio successfully
madvise(folio, MADV_HWPOISON) unmap(folio)
try_memory_failure_hugetlb
get_huge_page_for_hwpoison
spin_lock_irq(&hugetlb_lock) <- held
__get_huge_page_for_hwpoison
hugetlb_update_hwpoison()
-> MF_HUGETLB_FOLIO_PRE_POISONED
goto out:
folio_put()
refcount: 1 -> 0
free_huge_folio()
spin_lock_irqsave(&hugetlb_lock)
-> AA DEADLOCK!
The out: path in __get_huge_page_for_hwpoison() calls folio_put() to drop
the GUP reference while the hugetlb_lock is still held by the hugetlb.c
wrapper get_huge_page_for_hwpoison(). If concurrent unmap has released
the page table mapping reference, folio_put() drops the folio refcount to
zero, triggering free_huge_folio() which attempts to re-acquire the
non-recursive hugetlb_lock.
Fix this by moving hugetlb_lock acquisition from the hugetlb.c wrapper
into get_huge_page_for_hwpoison(). Place spin_unlock_irq() before the
folio_put() at the out: label so the folio is always released outside the
lock.
[akpm@linux-foundation.org: fix race, rename label per Miaohe]
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: reject BR/EDR signaling packets over MTUsig
net/bluetooth/l2cap_core.c:l2cap_sig_channel() accepts BR/EDR
signaling packets up to the channel MTU and dispatches each command
without enforcing the signaling MTU (MTUsig). A Bluetooth BR/EDR peer
within radio range can send a fixed-channel CID 0x0001 packet that is
larger than MTUsig and contains many L2CAP_ECHO_REQ commands before
pairing. In a real-radio stock-kernel run, one 681-byte signaling
packet containing 168 zero-length ECHO_REQ commands made the target
transmit 168 ECHO_RSP frames over about 220 ms.
Impact: a Bluetooth BR/EDR peer within radio range, before pairing, can
force 168 ECHO_RSP frames from one 681-byte fixed-channel signaling
packet containing packed ECHO_REQ commands.
Define Linux's BR/EDR signaling MTU as the spec minimum of 48 bytes and
reject any larger signaling packet with one L2CAP_COMMAND_REJECT_RSP
carrying L2CAP_REJ_MTU_EXCEEDED before any command is dispatched.
The Bluetooth Core spec wording for MTUExceeded says the reject
identifier shall match the first request command in the packet, and
that packets containing only responses shall be silently discarded.
Linux intentionally deviates from that prescription: silently
discarding desynchronizes the peer because the remote stack never
learns its responses were dropped, and locating the first request
command requires walking command headers past MTUsig, i.e. processing
bytes from a packet we have already decided is too large to process.
We therefore always emit one reject and use the identifier from the
first command header, a single fixed-offset byte read.
The unrestricted BR/EDR signaling parser and ECHO_REQ response path both
trace to the initial git import; no later introducing commit is
available for a Fixes tag.
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: reject oversized Broadcast Announcement prepend
Existing advertising instances can already hold the maximum extended
advertising payload. When hci_adv_bcast_annoucement() prepends the
Broadcast Announcement service data to that payload, the combined data
may no longer fit in the temporary buffer used to rebuild the
advertising data.
Reject that case before copying the existing payload and report the
failure through the device log. This keeps the existing advertising
data intact and avoids overrunning the temporary buffer.
In the Linux kernel, the following vulnerability has been resolved:
tee: shm: fix shm leak in register_shm_helper()
register_shm_helper() allocates shm before calling
iov_iter_npages(). If iov_iter_npages() returns 0, the function
jumps to err_ctx_put and leaks shm.
This can be triggered by TEE_IOC_SHM_REGISTER with
struct tee_ioctl_shm_register_data where length is 0.
Jump to err_free_shm instead.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_meta_bridge: fix stale stack leak via IIFHWADDR register
NFT_META_BRI_IIFHWADDR declares its destination register with
len = ETH_ALEN (6 bytes), which the register-init tracking rounds up to
two 32-bit registers (8 bytes). nft_meta_bridge_get_eval() then does
memcpy(dest, br_dev->dev_addr, ETH_ALEN), writing only 6 bytes and
leaving the upper 2 bytes of the second register as uninitialised
nft_do_chain() stack. A downstream load of that register span leaks
those stale bytes to userspace.
Zero the second register before the memcpy so the full declared span is
written.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_tunnel: fix use-after-free on object destroy
nft_tunnel_obj_destroy() calls metadata_dst_free() which directly
kfree()s the metadata_dst, ignoring the dst_entry refcount. Packets
that took a reference via dst_hold() in nft_tunnel_obj_eval() and
are still queued (e.g. in a netem qdisc) are left with a dangling
pointer. When these packets are eventually dequeued, dst_release()
operates on freed memory.
Replace metadata_dst_free() with dst_release() so the metadata_dst
is freed only after all references are dropped. The dst subsystem
already handles metadata_dst cleanup in dst_destroy() when
DST_METADATA is set.
In the Linux kernel, the following vulnerability has been resolved:
drm/vc4: fix krealloc() memory leak
Don't just overwrite the original pointer passed to krealloc()
with its return value without checking latter:
MEM = krealloc(MEM, SZ, GFP);
If krealloc() returns NULL, that erases the pointer
to the still allocated memory, hence leaks this memory.
Instead, use a temporary variable, check it's not NULL
and only then assign it to the original pointer:
TMP = krealloc(MEM, SZ, GFP);
if (!TMP) return;
MEM = TMP;
While on it, use krealloc_array().
In the Linux kernel, the following vulnerability has been resolved:
accel/ivpu: Fix signed integer truncation in IPC receive
Fix potential buffer overflow where firmware-supplied data_size is cast
to signed int before being used in min_t(). Large unsigned values
(>= 0x80000000) become negative, causing unsigned wraparound and
oversized memcpy operations that can overflow the stack buffer.
Change min_t(int, ...) to min() as both values are unsigned and can be
handled by min() without explicit cast.
In the Linux kernel, the following vulnerability has been resolved:
accel/ivpu: Add buffer overflow check in MS get_info_ioctl
Add validation that the info size returned from the metric stream info
query is not exceeded when checked against the allocated buffer size.
If the firmware returns a size larger than the buffer, reject the
operation with -EOVERFLOW instead of proceeding with an incorrect
buffer copy.