In the Linux kernel, the following vulnerability has been resolved:
net: macb: use the current queue number for stats
There's a potential mismatch between the memory reserved for statistics
and the amount of memory written.
gem_get_sset_count() correctly computes the number of stats based on the
active queues, whereas gem_get_ethtool_stats() indiscriminately copies
data using the maximum number of queues, and in the case the number of
active queues is less than MACB_MAX_QUEUES, this results in a OOB write
as observed in the KASAN splat.
==================================================================
BUG: KASAN: vmalloc-out-of-bounds in gem_get_ethtool_stats+0x54/0x78
[macb]
Write of size 760 at addr ffff80008080b000 by task ethtool/1027
CPU: [...]
Tainted: [E]=UNSIGNED_MODULE
Hardware name: raspberrypi rpi/rpi, BIOS 2025.10 10/01/2025
Call trace:
show_stack+0x20/0x38 (C)
dump_stack_lvl+0x80/0xf8
print_report+0x384/0x5e0
kasan_report+0xa0/0xf0
kasan_check_range+0xe8/0x190
__asan_memcpy+0x54/0x98
gem_get_ethtool_stats+0x54/0x78 [macb
926c13f3af83b0c6fe64badb21ec87d5e93fcf65]
dev_ethtool+0x1220/0x38c0
dev_ioctl+0x4ac/0xca8
sock_do_ioctl+0x170/0x1d8
sock_ioctl+0x484/0x5d8
__arm64_sys_ioctl+0x12c/0x1b8
invoke_syscall+0xd4/0x258
el0_svc_common.constprop.0+0xb4/0x240
do_el0_svc+0x48/0x68
el0_svc+0x40/0xf8
el0t_64_sync_handler+0xa0/0xe8
el0t_64_sync+0x1b0/0x1b8
The buggy address belongs to a 1-page vmalloc region starting at
0xffff80008080b000 allocated at dev_ethtool+0x11f0/0x38c0
The buggy address belongs to the physical page:
page: refcount:1 mapcount:0 mapping:0000000000000000
index:0xffff00000a333000 pfn:0xa333
flags: 0x7fffc000000000(node=0|zone=0|lastcpupid=0x1ffff)
raw: 007fffc000000000 0000000000000000 dead000000000122 0000000000000000
raw: ffff00000a333000 0000000000000000 00000001ffffffff 0000000000000000
page dumped because: kasan: bad access detected
Memory state around the buggy address:
ffff80008080b080: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
ffff80008080b100: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
>ffff80008080b180: 00 00 00 00 00 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8
^
ffff80008080b200: f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8
ffff80008080b280: f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8 f8
==================================================================
Fix it by making sure the copied size only considers the active number of
queues.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ctnetlink: use netlink policy range checks
Replace manual range and mask validations with netlink policy
annotations in ctnetlink code paths, so that the netlink core rejects
invalid values early and can generate extack errors.
- CTA_PROTOINFO_TCP_STATE: reject values > TCP_CONNTRACK_SYN_SENT2 at
policy level, removing the manual >= TCP_CONNTRACK_MAX check.
- CTA_PROTOINFO_TCP_WSCALE_ORIGINAL/REPLY: reject values > TCP_MAX_WSCALE
(14). The normal TCP option parsing path already clamps to this value,
but the ctnetlink path accepted 0-255, causing undefined behavior when
used as a u32 shift count.
- CTA_FILTER_ORIG_FLAGS/REPLY_FLAGS: use NLA_POLICY_MASK with
CTA_FILTER_F_ALL, removing the manual mask checks.
- CTA_EXPECT_FLAGS: use NLA_POLICY_MASK with NF_CT_EXPECT_MASK, adding
a new mask define grouping all valid expect flags.
Extracted from a broader nf-next patch by Florian Westphal, scoped to
ctnetlink for the fixes tree.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_conntrack_expect: skip expectations in other netns via proc
Skip expectations that do not reside in this netns.
Similar to e77e6ff502ea ("netfilter: conntrack: do not dump other netns's
conntrack entries via proc").
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btusb: clamp SCO altsetting table indices
btusb_work() maps the number of active SCO links to USB alternate
settings through a three-entry lookup table when CVSD traffic uses
transparent voice settings. The lookup currently indexes alts[] with
data->sco_num - 1 without first constraining sco_num to the number of
available table entries.
While the table only defines alternate settings for up to three SCO
links, data->sco_num comes from hci_conn_num() and is used directly.
Cap the lookup to the last table entry before indexing it so the
driver keeps selecting the highest supported alternate setting without
reading past alts[].
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/core) Protect regulator operations with mutex
The regulator operations pmbus_regulator_get_voltage(),
pmbus_regulator_set_voltage(), and pmbus_regulator_list_voltage()
access PMBus registers and shared data but were not protected by
the update_lock mutex. This could lead to race conditions.
However, adding mutex protection directly to these functions causes
a deadlock because pmbus_regulator_notify() (which calls
regulator_notifier_call_chain()) is often called with the mutex
already held (e.g., from pmbus_fault_handler()). If a regulator
callback then calls one of the now-protected voltage functions,
it will attempt to acquire the same mutex.
Rework pmbus_regulator_notify() to utilize a worker function to
send notifications outside of the mutex protection. Events are
stored as atomics in a per-page bitmask and processed by the worker.
Initialize the worker and its associated data during regulator
registration, and ensure it is cancelled on device removal using
devm_add_action_or_reset().
While at it, remove the unnecessary include of linux/of.h.
In the Linux kernel, the following vulnerability has been resolved:
spi: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
Also note that we do not enable the driver_override feature of struct
bus_type, as SPI - in contrast to most other buses - passes "" to
sysfs_emit() when the driver_override pointer is NULL. Thus, printing
"\n" instead of "(null)\n".
In the Linux kernel, the following vulnerability has been resolved:
spi: spi-fsl-lpspi: fix teardown order issue (UAF)
There is a teardown order issue in the driver. The SPI controller is
registered using devm_spi_register_controller(), which delays
unregistration of the SPI controller until after the fsl_lpspi_remove()
function returns.
As the fsl_lpspi_remove() function synchronously tears down the DMA
channels, a running SPI transfer triggers the following NULL pointer
dereference due to use after free:
| fsl_lpspi 42550000.spi: I/O Error in DMA RX
| Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000
[...]
| Call trace:
| fsl_lpspi_dma_transfer+0x260/0x340 [spi_fsl_lpspi]
| fsl_lpspi_transfer_one+0x198/0x448 [spi_fsl_lpspi]
| spi_transfer_one_message+0x49c/0x7c8
| __spi_pump_transfer_message+0x120/0x420
| __spi_sync+0x2c4/0x520
| spi_sync+0x34/0x60
| spidev_message+0x20c/0x378 [spidev]
| spidev_ioctl+0x398/0x750 [spidev]
[...]
Switch from devm_spi_register_controller() to spi_register_controller() in
fsl_lpspi_probe() and add the corresponding spi_unregister_controller() in
fsl_lpspi_remove().
In the Linux kernel, the following vulnerability has been resolved:
media: mc, v4l2: serialize REINIT and REQBUFS with req_queue_mutex
MEDIA_REQUEST_IOC_REINIT can run concurrently with VIDIOC_REQBUFS(0)
queue teardown paths. This can race request object cleanup against vb2
queue cancellation and lead to use-after-free reports.
We already serialize request queueing against STREAMON/OFF with
req_queue_mutex. Extend that serialization to REQBUFS, and also take
the same mutex in media_request_ioctl_reinit() so REINIT is in the
same exclusion domain.
This keeps request cleanup and queue cancellation from running in
parallel for request-capable devices.
In the Linux kernel, the following vulnerability has been resolved:
xfs: stop reclaim before pushing AIL during unmount
The unmount sequence in xfs_unmount_flush_inodes() pushed the AIL while
background reclaim and inodegc are still running. This is broken
independently of any use-after-free issues - background reclaim and
inodegc should not be running while the AIL is being pushed during
unmount, as inodegc can dirty and insert inodes into the AIL during the
flush, and background reclaim can race to abort and free dirty inodes.
Reorder xfs_unmount_flush_inodes() to stop inodegc and cancel background
reclaim before pushing the AIL. Stop inodegc before cancelling
m_reclaim_work because the inodegc worker can re-queue m_reclaim_work
via xfs_inodegc_set_reclaimable.
In the Linux kernel, the following vulnerability has been resolved:
crypto: algif_aead - Revert to operating out-of-place
This mostly reverts commit 72548b093ee3 except for the copying of
the associated data.
There is no benefit in operating in-place in algif_aead since the
source and destination come from different mappings. Get rid of
all the complexity added for in-place operation and just copy the
AD directly.