Linux: >> Linux Kernel >> 6.1.104 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
ipmi:si: Return state to normal if message allocation fails
There were places where nothing would get started if a message
allocation failed, so the driver needs to return to normal state.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
net: stmmac: Prevent NULL deref when RX memory exhausted
The CPU receives frames from the MAC through conventional DMA: the CPU
allocates buffers for the MAC, then the MAC fills them and returns
ownership to the CPU. For each hardware RX queue, the CPU and MAC
coordinate through a shared ring array of DMA descriptors: one
descriptor per DMA buffer. Each descriptor includes the buffer's
physical address and a status flag ("OWN") indicating which side owns
the buffer: OWN=0 for CPU, OWN=1 for MAC. The CPU is only allowed to set
the flag and the MAC is only allowed to clear it, and both must move
through the ring in sequence: thus the ring is used for both
"submissions" and "completions."
In the stmmac driver, stmmac_rx() bookmarks its position in the ring
with the `cur_rx` index. The main receive loop in that function checks
for rx_descs[cur_rx].own=0, gives the corresponding buffer to the
network stack (NULLing the pointer), and increments `cur_rx` modulo the
ring size. After the loop exits, stmmac_rx_refill(), which bookmarks its
position with `dirty_rx`, allocates fresh buffers and rearms the
descriptors (setting OWN=1). If it fails any allocation, it simply stops
early (leaving OWN=0) and will retry where it left off when next called.
This means descriptors have a three-stage lifecycle (terms my own):
- `empty` (OWN=1, buffer valid)
- `full` (OWN=0, buffer valid and populated)
- `dirty` (OWN=0, buffer NULL)
But because stmmac_rx() only checks OWN, it confuses `full`/`dirty`. In
the past (see 'Fixes:'), there was a bug where the loop could cycle
`cur_rx` all the way back to the first descriptor it dirtied, resulting
in a NULL dereference when mistaken for `full`. The aforementioned
commit resolved that *specific* failure by capping the loop's iteration
limit at `dma_rx_size - 1`, but this is only a partial fix: if the
previous stmmac_rx_refill() didn't complete, then there are leftover
`dirty` descriptors that the loop might encounter without needing to
cycle fully around. The current code therefore panics (see 'Closes:')
when stmmac_rx_refill() is memory-starved long enough for `cur_rx` to
catch up to `dirty_rx`.
Fix this by explicitly checking, before advancing `cur_rx`, if the next
entry is dirty; exit the loop if so. This prevents processing of the
final, used descriptor until stmmac_rx_refill() succeeds, but
fully prevents the `cur_rx == dirty_rx` ambiguity as the previous bugfix
intended: so remove the clamp as well. Since stmmac_rx_zc() is a
copy-paste-and-tweak of stmmac_rx() and the code structure is identical,
any fix to stmmac_rx() will also need a corresponding fix for
stmmac_rx_zc(). Therefore, apply the same check there.
In stmmac_rx() (not stmmac_rx_zc()), a related bug remains: after the
MAC sets OWN=0 on the final descriptor, it will be unable to send any
further DMA-complete IRQs until it's given more `empty` descriptors.
Currently, the driver simply *hopes* that the next stmmac_rx_refill()
succeeds, risking an indefinite stall of the receive process if not. But
this is not a regression, so it can be addressed in a future change.
CVSS Score
7.5
EPSS Score
0.005
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_conn: fix potential UAF in create_big_sync
Add hci_conn_valid() check in create_big_sync() to detect stale
connections before proceeding with BIG creation. Handle the
resulting -ECANCELED in create_big_complete() and re-validate the
connection under hci_dev_lock() before dereferencing, matching the
pattern used by create_le_conn_complete() and create_pa_complete().
Keep the hci_conn object alive across the async boundary by taking
a reference via hci_conn_get() when queueing create_big_sync(), and
dropping it in the completion callback. The refcount and the lock
are complementary: the refcount keeps the object allocated, while
hci_dev_lock() serializes hci_conn_hash_del()'s list_del_rcu() on
hdev->conn_hash, as required by hci_conn_del().
hci_conn_put() is called outside hci_dev_unlock() so the final put
(which resolves to kfree() via bt_link_release) does not run under
hdev->lock, though the release path would be safe either way.
Without this, create_big_complete() would unconditionally
dereference the conn pointer on error, causing a use-after-free
via hci_connect_cfm() and hci_conn_del().
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
RDMA/hns: Fix unlocked call to hns_roce_qp_remove()
Sashiko points out that hns_roce_qp_remove() requires the caller to hold
locks. The error flow in hns_roce_create_qp_common() doesn't hold those
locks for the error unwind so it risks corrupting memory.
Grab the same locks the other two callers use.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
KVM: x86: Fix shadow paging use-after-free due to unexpected GFN
The shadow MMU computes GFNs for direct shadow pages using sp->gfn plus
the SPTE index. This assumption breaks for shadow paging if the guest
page tables are modified between VM entries (similar to commit
aad885e77496, "KVM: x86/mmu: Drop/zap existing present SPTE even
when creating an MMIO SPTE", 2026-03-27). The flow is as follows:
- a PDE is installed for a 2MB mapping, and a page in that area is
accessed. KVM creates a kvm_mmu_page consisting of 512 4KB pages;
the kvm_mmu_page is marked by FNAME(fetch) as direct-mapped because
the guest's mapping is a huge page (and thus contiguous).
- the PDE mapping is changed from outside the guest.
- the guest accesses another page in the same 2MB area. KVM installs
a new leaf SPTE and rmap entry; the SPTE uses the "correct" GFN
(i.e. based on the new mapping, as changed in the previous step) but
that GFN is outside of the [sp->gfn, sp->gfn + 511] range; therefore
the rmap entry cannot be found and removed when the kvm_mmu_page
is zapped.
- the memslot that covers the first 2MB mapping is deleted, and the
kvm_mmu_page for the now-invalid GPA is zapped. However, rmap_remove()
only looks at the [sp->gfn, sp->gfn + 511] range established in step 1,
and fails to find the rmap entry that was recorded by step 3.
- any operation that causes an rmap walk for the same page accessed
by step 3 then walks a stale rmap and dereferences a freed kvm_mmu_page.
This includes dirty logging or MMU notifier invalidations (e.g., from
MADV_DONTNEED).
The underlying issue is that KVM's walking of shadow PTEs assumes that
if a SPTE is present when KVM wants to install a non-leaf SPTE, then the
existing kvm_mmu_page must be for the correct gfn. Because the only way
for the gfn to be wrong is if KVM messed up and failed to zap a SPTE...
which shouldn't happen, but *actually* only happens in response to a
guest write.
That bug dates back literally forever, as even the first version of KVM
assumes that the GFN matches and walks into the "wrong" shadow page.
However, that was only an imprecision until 2032a93d66fa ("KVM: MMU:
Don't allocate gfns page for direct mmu pages") came along.
Fix it by checking for a target gfn mismatch and zapping the existing
SPTE. That way the old SP and rmap entries are gone, KVM installs
the rmap in the right location, and everyone is happy.
CVSS Score
8.8
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
netfilter: reject zero shift in nft_bitwise
Reject zero shift operands for nft_bitwise left and right shift
expressions during initialization.
The carry propagation logic computes the carry from the adjacent 32-bit
word using BITS_PER_TYPE(u32) - shift. A zero shift operand turns this
into a 32-bit shift, which is undefined behaviour.
Reject zero shift operands in the control plane, alongside the existing
check for values greater than or equal to 32, so malformed rules never
reach the packet path.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
net: strparser: fix skb_head leak in strp_abort_strp()
When the stream parser is aborted, for example after a message assembly timeout,
it can still hold a reference to a partially assembled message in
strp->skb_head.
That skb is not released in strp_abort_strp(), which leaks the partially
assembled message and can be triggered repeatedly to exhaust memory.
Fix this by freeing strp->skb_head and resetting the parser state in the
abort path. Leave strp_stop() unchanged so final cleanup still happens in
strp_done() after the work and timer have been synchronized.
CVSS Score
7.5
EPSS Score
0.005
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
can: ucan: fix devres lifetime
USB drivers bind to USB interfaces and any device managed resources
should have their lifetime tied to the interface rather than parent USB
device. This avoids issues like memory leaks when drivers are unbound
without their devices being physically disconnected (e.g. on probe
deferral or configuration changes).
Fix the control message buffer lifetime so that it is released on driver
unbind.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
net: caif: clear client service pointer on teardown
`caif_connect()` can tear down an existing client after remote shutdown by
calling `caif_disconnect_client()` followed by `caif_free_client()`.
`caif_free_client()` releases the service layer referenced by
`adap_layer->dn`, but leaves that pointer stale.
When the socket is later destroyed, `caif_sock_destructor()` calls
`caif_free_client()` again and dereferences the freed service pointer.
Clear the client/service links before releasing the service object so
repeated teardown becomes harmless.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
net: ipv6: fix NOREF dst use in seg6 and rpl lwtunnels
seg6_input_core() and rpl_input() call ip6_route_input() which sets a
NOREF dst on the skb, then pass it to dst_cache_set_ip6() invoking
dst_hold() unconditionally.
On PREEMPT_RT, ksoftirqd is preemptible and a higher-priority task can
release the underlying pcpu_rt between the lookup and the caching
through a concurrent FIB lookup on a shared nexthop.
Simplified race sequence:
ksoftirqd/X higher-prio task (same CPU X)
----------- --------------------------------
seg6_input_core(,skb)/rpl_input(skb)
dst_cache_get()
-> miss
ip6_route_input(skb)
-> ip6_pol_route(,skb,flags)
[RT6_LOOKUP_F_DST_NOREF in flags]
-> FIB lookup resolves fib6_nh
[nhid=N route]
-> rt6_make_pcpu_route()
[creates pcpu_rt, refcount=1]
pcpu_rt->sernum = fib6_sernum
[fib6_sernum=W]
-> cmpxchg(fib6_nh.rt6i_pcpu,
NULL, pcpu_rt)
[slot was empty, store succeeds]
-> skb_dst_set_noref(skb, dst)
[dst is pcpu_rt, refcount still 1]
rt_genid_bump_ipv6()
-> bumps fib6_sernum
[fib6_sernum from W to Z]
ip6_route_output()
-> ip6_pol_route()
-> FIB lookup resolves fib6_nh
[nhid=N]
-> rt6_get_pcpu_route()
pcpu_rt->sernum != fib6_sernum
[W <> Z, stale]
-> prev = xchg(rt6i_pcpu, NULL)
-> dst_release(prev)
[prev is pcpu_rt,
refcount 1->0, dead]
dst = skb_dst(skb)
[dst is the dead pcpu_rt]
dst_cache_set_ip6(dst)
-> dst_hold() on dead dst
-> WARN / use-after-free
For the race to occur, ksoftirqd must be preemptible (PREEMPT_RT without
PREEMPT_RT_NEEDS_BH_LOCK) and a concurrent task must be able to release
the pcpu_rt. Shared nexthop objects provide such a path, as two routes
pointing to the same nhid share the same fib6_nh and its rt6i_pcpu
entry.
Fix seg6_input_core() and rpl_input() by calling skb_dst_force() after
ip6_route_input() to force the NOREF dst into a refcounted one before
caching.
The output path is not affected as ip6_route_output() already returns a
refcounted dst.
CVSS Score
8.1
EPSS Score
0.004
Published
2026-05-27